LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Control System - 4.8L, 5.3L & 6.0L (DTC P0140 Or P0160 To DTC P0449)) >> Diagnostic Information and Procedures >> DTC P0449 >> Circuit Description

Circuit Description

WARNING: This page is about a different variant/trim than selected.

A battery positive is supplied to the evaporative emission (EVAP) canister vent solenoid valve. The control module grounds the EVAP canister vent solenoid valve control circuit to close the valve by means of an internal switch called a driver. The scan tool displays the commanded state of the EVAP canister vent solenoid valve as ON or OFF. The control module monitors the status of the driver. If the control module detects an incorrect voltage for the commanded state of the driver, this DTC sets.

The following table illustrates the relationship between the ON and OFF states, and the OPEN or CLOSED states of the EVAP canister vent solenoid valve.

ON & OFF State Of EVAP Canister Vent Solenoid Valve

Control Module Command EVAP Canister Vent Solenoid Valve Position
ON CLOSED
OFF OPEN
scientia non olet · About LEMON Manuals