LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical (Repair Instructions -- 2 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (Off-Vehicle - Part 2) >> Valve Rocker Arm Cover Removal - Left

Valve Rocker Arm Cover Removal - Left

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Do not remove the ignition coils and bracket from the valve rocker arm cover unless required.
  1. Remove the ignition coil bracket bolts from the rocker arm cover, if required.
  2. Remove the ignition coil and bracket assembly from the cover.
  3. Fig 1: View Of Ignition Coil, Bracket Assembly, Wire Harness & Bolts (Left)
    GM1342458Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve rocker arm cover bolts.
  5. Remove the valve rocker arm cover.
  6. Fig 2: View Of Valve Rocker Arm Cover
    GM1277108Courtesy of GENERAL MOTORS CORP.
  7. Remove the gasket (504) from the left cover.
  8. Discard the gasket.

    The bolt grommets may be used again if they are not damaged.

  9. Fig 3: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.