LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical (Repair Instructions -- 2 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (Off-Vehicle - Part 2) >> Engine Valley Cover Cleaning and Inspection

Engine Valley Cover Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT:
    • Do not use the valley cover knock sensor oil seals again. Install NEW oil seals during assembly.
    • Do not use the valley cover gasket again. Install a NEW gasket during assembly.
  1. Remove the knock sensor oil seals (520) from the valley cover (555).
    2. Fig 1: View Of Knock Sensor Oil Seals & Valley Cover
    GM1277106Courtesy of GENERAL MOTORS CORP.
  2. Clean the valley cover in solvent.
    3. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  3. Dry the valley cover with compressed air.
  4. Inspect the gasket sealing surfaces for excessive scratches or gouging. Refer to Replacing Engine Gaskets .
  5. Inspect the valley cover oil seal bores for excessive scratches or gouging.
scientia non olet · About LEMON Manuals