LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical (Introduction) 4.8L, 5.3L & 6.0L) >> Diagnostic Information and Procedures >> Drive Belt Tensioner Diagnosis >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Allowing the drive belt tensioner to snap into the free position may result in damage to the tensioner.
    IMPORTANT: When the engine is operating the drive belt tensioner arm will move. Do not replace the drive belt tensioner because of movement in the drive belt tensioner arm.
  1. Remove the drive belt. Refer to Drive Belt Replacement - Accessory or Drive Belt Replacement - Air Conditioning .
  2. Move the drive belt tensioner through its full travel.
    • The movement should feel smooth.
    • There should be no binding.
    • The tensioner should return freely.
    3. Fig 1: Releasing Drive Belt Tension
    GM374176Courtesy of GENERAL MOTORS CORP.
  3. If any binding is observed, replace the drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Accessory or Drive Belt Tensioner Replacement - Air Conditioning .
  4. Install the drive belt. Refer to of Drive Belt Replacement - Accessory or Drive Belt Replacement - Air Conditioning .
scientia non olet · About LEMON Manuals