Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Escalade EXT, 2004 Cadillac Escalade ESV, and 2004 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the speed sensor with a NEW O-ring.
Tighten: Tighten the sensor to 17 N.m (13 lb ft).

Fig 1: View Of Vehicle Speed Sensor (VSS) & O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Connect the speed sensor electrical connector (4).
Lower the vehicle.

Fig 2: View Of Speed Sensor Electrical Connectors & Bracket Clips

Courtesy of GENERAL MOTORS CORP.