LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Transfer Case - BW 4481-Nr3) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Escalade EXT, 2004 Cadillac Escalade ESV, and 2004 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 45756  , install a NEW front output shaft seal. See Special Tools and Equipment .
    2. Fig 1: Installing Rear Output Shaft Seal Using J 45756
    GM833029Courtesy of GENERAL MOTORS CORP.
  2. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  3. Check the fluid level. Add fluid, if necessary.
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals