LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Transfer Case - BW 4481-Nr3) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Escalade EXT, 2004 Cadillac Escalade ESV, and 2004 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J 43484  (2) to the J 8092  (1). See Special Tools and Equipment .
  2. Install a NEW seal onto J 43484  . See Special Tools and Equipment .
  3. Using J 43484  (2), and J 8092  (1), install the seal. See Special Tools and Equipment .
    4. Fig 1: Installing J 43484 To J 8092
    GM819655Courtesy of GENERAL MOTORS CORP.
  4. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  5. Check the fluid level. Add fluid, if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals