LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Transfer Case - BW 4481-Nr3) >> Repair Instructions >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Escalade EXT, 2004 Cadillac Escalade ESV, and 2004 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of or with the seal.
  1. Install a NEW seal onto the adapter.
    2. IMPORTANT: The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the adapter.
  3. Install the adapter bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    4. Fig 1: View Of Transfer Case Adapter, Bolts & Seal
    GM652614Courtesy of GENERAL MOTORS CORP.
  4. Install the transfer case. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals