LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 412 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (8.1L Engine) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Outlet Hose To The Water Pump
    GM751427Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System .
  2. Remove the drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 8.1 L.
  3. Remove the fan clutch. Refer to Fan Clutch Replacement .
  4. Position the outlet hose clamp at the water pump.
  5. Remove the outlet hose from the water pump.
    6. Fig 2: View Of Bypass Hose (8.1L)
    GM846662Courtesy of GENERAL MOTORS CORP.
  6. Position the bypass hose clamps at the water pump and water crossover.
  7. Remove the bypass hose.
    8. Fig 3: View Of Water Pump & Gasket
    GM470790Courtesy of GENERAL MOTORS CORP.
  8. Remove the water pump bolts.
  9. Remove the water pump.
  10. Remove and discard the water pump gaskets.
scientia non olet · About LEMON Manuals