Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Upper Fan Shroud

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the upper fan shroud.
Install the fan shroud bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 2: View Of Fan Shroud Retainers

Courtesy of GENERAL MOTORS CORP.

Install the fan shroud retainers.

Fig 3: View Of TCM Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the TCM electrical connectors (1).
Install the TCM and cover.
Tighten the TCM electrical connector bolts.
Tighten: Tighten the bolts to 8 N.m (71 lb in).

Fig 4: View Of TCM Cover & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the TCM cover to the fan shroud.
Install the TCM cover bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 5: View Of Engine Harness Clip At PCM Cover

Courtesy of GENERAL MOTORS CORP.

Install the engine harness clip to the PCM cover.
Install the A/C line retainer to the fan shroud.

Fig 6: View Of Air Cleaner Outlet Duct

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner outlet duct.
Tighten the air cleaner outlet duct clamp at the throttle body.
Tighten: Tighten the clamp screws to 7 N.m (62 lb in).
Tighten the air cleaner outlet duct clamp at the mass airflow sensor.
Tighten: Tighten the clamp screws to 7 N.m (62 lb in).