Engine Overheated Indicator Always On

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Connector End View Reference: Engine Cooling Schematics DEFINITION: One of the following engine coolant temperature indicators is always On: Engine Coolant, Engine Coolant Hot/Idle Engine, Engine Hot-AC Off, Engine Overheated/Stop Engine.
1	Did you perform the Engine Cooling Diagnostic System Check?	Go to Step 2	Go To Diagnostic System Check - Engine Cooling
2	Start the engine. Does the Engine Coolant Temperature indicator illuminate?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Install a scan tool. With the scan tool, observe the engine coolant temperature parameter in the powertrain control module (PCM) data list. Does the scan tool indicate that the coolant temperature is within the temperature range shown on the temperature gage?	Go to Engine Overheating	Go to Step 4
4	Replace the instrument panel cluster (IPC). Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages, and Console. Did you complete the replacement?	Go to Step 5	-
5	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2