LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 411 (Transfer Case - BW 4482-Nr4) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL and 2004 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the vehicle is a 2500 series, position the transfer case shield, if equipped.
  2. Install the transfer case shield screws, if equipped.
    3. Fig 1: View Of Transfer Case Shield & Screws (2500 Series)
    GM396828Courtesy of GENERAL MOTORS CORP.
  3. If the vehicle is a 1500 series, position the transfer case shield, if equipped.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the transfer case shield bolts, if equipped.

    Tighten:  Tighten the bolts/screws to 20 N.m (15 lb ft).

    5. Fig 2: View Of Transfer Case Shield & Bolts
    GM826834Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals