LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 411 (Transfer Case - BW 4482-Nr4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL and 2004 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the J 45756  , install a NEW output shaft seal.
    2. Fig 1: Installing Rear Output Shaft Seal Using Screwdriver
    GM819663Courtesy of GENERAL MOTORS CORP.
  2. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  3. Check the fluid level. Add fluid if necessary.
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals