LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 411 (Transfer Case - BW 4482-Nr4) >> Repair Instructions >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL and 2004 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When performing the following procedures, use only hand tools to remove and install the drain and fill plugs.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the fill plug.
  4. Remove the drain plug.
  5. Allow the transfer case fluid to drain completely.
    6. Fig 1: View Of Transfer Case Plug
    GM819569Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals