LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 411 (Transfer Case - BW 4482-Nr4) >> Repair Instructions >> Transfer Case Encoder Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL and 2004 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  3. Disconnect the encoder motor electrical connector (2).
    4. Fig 1: View Of Speed Sensor & Encoder Motor Electrical Connectors
    GM856630Courtesy of GENERAL MOTORS CORP.
  4. Remove the encoder motor bolts.
  5. Remove the encoder motor.
    6. Fig 2: View Of Transfer Case Encoder Motor & Bolts
    GM819575Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals