LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

  1. Connect the IPC harness (1) to the IPC (2).
    2. Fig 1: Connecting Instrument Panel Cluster Harness
    GM854865Courtesy of GENERAL MOTORS CORP.
  2. Install the IPC onto the I/P with the screws. Tilt the top of the cluster into the retainer first to avoid damaging the flexible circuit connections.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws that retain the IPC to the I/P assembly.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    4. Fig 2: Installing Instrument Panel Cluster & Screws
    GM348794Courtesy of GENERAL MOTORS CORP.
  4. Install the IPC trim plate bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster .

    When the IPC is replaced the new IPC will need to be programmed. Refer to Service Programming System (SPS) in Programming and Setup.

scientia non olet · About LEMON Manuals