Installation Procedure

Install the heat/cool unit in the cup holder assembly from the front of the assembly.
Install the plastic cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the four retaining screws.
Tighten: Tighten the screws to 7 Nm (62 lb in).

Fig 1: Installing Cupholder (Platinum)

Courtesy of GENERAL MOTORS CORP.

Install the blower assembly. Refer to Blower Replacement - Cupholder - Front Floor Console .
Install the console bezel assembly to the console. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) .