Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws (1) that retain the upper console bracket to the lower console bracket.
Tighten: Tighten the retaining screws to 2 N.m (18 lb in).

Fig 1: Installing Screws Retaining Upper Console Bracket (W/O Console Mounting Bracket)

Courtesy of GENERAL MOTORS CORP.

Install the bolts (1) retaining the console to the I/P.
Tighten: Tighten the bolts to 4 N.m (35 lb in).

Fig 2: Installing Bolts Retaining Console To I/P (W/O Console Mounting Bracket)

Courtesy of GENERAL MOTORS CORP.

Install both front console side panel screws (1).
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 3: Locating Console Side Panel Screw

Courtesy of GENERAL MOTORS CORP.

Move both front seats to the fully forward.
Install both rear console side panel screws (2).
Tighten: Tighten the retaining screws to 2 N.m (18 lb in).
Reposition the inboard seat track trim (1).

Fig 4: View Of Seat Track Trim & Rear Console Side Panel Screw

Courtesy of GENERAL MOTORS CORP.

Connect the floor console electrical connector.
Install the center console end panel. Refer to Center Console End Panel Replacement .
Install the console storage bin. Refer to Console Storage Bin Replacement (Except Pro) .
Install the cupholder to the console. Refer to Cupholder Replacement (Non-Luxury) or Cupholder Replacement (Luxury) or Cupholder Replacement (Rear) or Cupholder Replacement (Platinum) .
Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) .
Install the radio amp fuse. Refer to Electrical Center Identification Views in Wiring Systems.