LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement (w/Console Mounting Bracket) >> Installation Procedure

Installation Procedure

  1. Install the rear seat audio control to the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
  2. Install the console in the vehicle.
  3. Connect the wire connectors.
  4. Move the console forward in order to install the retaining screws.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 2 screws (1).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    6. Fig 1: Identifying Bolts Retaining Console To Instrument Panel
    GM854810Courtesy of GENERAL MOTORS CORP.
  6. Install the cupholder to the console. Refer to Cupholder Replacement (Non-Luxury)  or Cupholder Replacement (Luxury)  or Cupholder Replacement (Rear)  or Cupholder Replacement (Platinum) .
  7. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper)  or Bezel Replacement - Floor Console (Luxury Upper) .
  8. Install the radio amp fuse, if removed. Refer to Electrical Center Identification Views in Wiring Systems.
  9. Install both front seats. Refer to Seat Replacement - Front Bucket in Seats.
scientia non olet · About LEMON Manuals