LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Bracket Replacement - Console Floor >> Installation Procedure

Installation Procedure

  1. Install the console to the bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fasteners retaining the console to the bracket.

    Tighten:  Tighten the fasteners to 2 N.m (17 lb in).

  3. Install the vehicle sensor to the bracket. Refer to Yaw Rate Sensor/Lateral Accelerometer Replacement Antilock Brake System.
  4. Install the amplifier and bracket to the console bracket. Refer to Amplifier Replacement in Entertainment.
  5. Install the console bin. Refer to Console Storage Bin Replacement (Except Pro) .
  6. Install the rear seat audio control to the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
  7. Install the console in the vehicle.
  8. Connect the wire connectors.
  9. Move the console forward in order to install the retaining screws.
  10. Install the 2 screws (1).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    11. Fig 1: Identifying Bolts Retaining Console To Instrument Panel
    GM854810Courtesy of GENERAL MOTORS CORP.
  11. Install the cupholder to the console. Refer to Cupholder Replacement (Non-Luxury)  or Cupholder Replacement (Luxury)  or Cupholder Replacement (Rear)  or Cupholder Replacement (Platinum) .
  12. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper)  or Bezel Replacement - Floor Console (Luxury Upper) .
  13. Install both front seats. Refer to Seat Replacement - Front Bucket in Seats.
scientia non olet · About LEMON Manuals