LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instruction >> Trim Plate Replacement - Instrument Panel (I/P) Accessory >> Removal Procedure

Removal Procedure

  1. Open the ashtray or the cupholder.
  2. Remove the following sets of screws:
    • Two screws from the front of the trim panel. For access to the front screws, remove the ashtray or the cupholder.
    • Two screws from the bottom of the trim panel. For access to the bottom screws, remove the console storage box.
  3. Use a small, flat-bladed tool in order to remove the upper tabs on the IP accessory trim plate from the instrument panel.
  4. Disconnect the electrical connectors, if equipped.
  5. Remove the IP accessory trim plate from the instrument panel.
    Fig 1: Removing Instrument Panel Accessory Trim Plate From Instrument Panel
    G01534508Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals