LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instruction >> Knee Bolster Replacement >> Removal Procedure

Removal Procedure

  1. Remove the IP insulator. Refer to one of the following procedures:
  2. Remove the bolts/screws from the bottom of the knee bolster.
  3. Pull on the knee bolster in order to release the upper clips.
    Fig 1: Removing Knee Bolster
    G01534506Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals