LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instruction >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

  1. Perform the following steps in order to install the knee bolster to the instrument panel:
    1. Align the clips with the slots in the instrument panel.
    2. Push in, in order to secure the knee bolster.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts/screws to the bottom of the knee bolster.

    Tighten 

    Tighten the bolts/screws to 2.5 N.m (22 lb in).

  3. Install the IP insulator. Refer to one of the following procedures:
    Fig 1: Installing Knee Bolster
    G01534507Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals