Removal Procedure

Important:  The ignition switch must be in the OFF position when removing the instrument panel cluster.

1. Remove the IP cluster trim plate. Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER  .
2. Remove the screws from the IP cluster to instrument panel.
   Fig 1: Removing From Instrument Panel Cluster Screws

   Courtesy of GENERAL MOTORS CORP.
3. Remove the IP cluster from the instrument panel.
4. Disconnect the electrical connectors.
   Fig 2: Disconnecting Electrical Connectors

   Courtesy of GENERAL MOTORS CORP.