LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instruction >> Instrument Panel (I/P) Multifunction Switch Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Connect the electrical connectors.
  2. Install the switch bank into the IP by pushing in on the switch bank.
    Fig 1: Connecting Electrical Connectors
    G01534492Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the bolts/screws to secure the switch bank to the instrument panel.

    Tighten 

    Tighten the bolts/screws to 2.5 N.m (22 lb in).

    Fig 2: Installing Switch Bank To Instrument Panel
    G01534493Courtesy of GENERAL MOTORS CORP.
  4. Install the IP accessory trim plate. Refer to TRIM PAD REPLACEMENT - INSTRUMENT PANEL (I/P) UPPER  .
    Fig 3: Identifying Instrument Panel
    G01534494Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals