Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Tracker 2D Utility, 4WD, Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 2.2 | B | ||
| Front | 1.0 | 1.0 | B | |
| Rear | 1.4 | 0.8 | B | |
| Combination Procedure: AXLE BEARING: Replace: | ||||
| Rear,Both | 0.8 | B | ||
| Rear,One Side | 0.6 | B | ||
| Combination Procedure: AXLE SEAL: Replace: Semi-Floating Axle. | ||||
| Rear,Both | 0.8 | B | ||
| Rear,One Side | 0.6 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional,w/ABS | 0.2 | B | ||
| Each Additional,w/o ABS | 0.2 | B | ||
| One,w/ABS | Includes: Bleed Brakes. | 0.5 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.5 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| 4WD, Each | Includes: Repack Wheel Bearings (where applicable). | 0.7 | B | |
| Combination Procedure: DISC ROTOR: Replace: | ||||
| 4WD, Each | Includes: Repack Wheel Bearings (where applicable). | 0.7 | B | |
| Combination Procedure: DRUM: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,One Side | 0.8 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.5 | B | |
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |