LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder Reservoir >> Installation

Master Cylinder Reservoir: Installation

  1. Lubricate new grommets with Delco(R) Supreme 11, (12377967 US; 992667 Canada), or equivalent DOT-3 brake fluid. See Figure . Press fit the grommets to the master cylinder, and seat the grommets in place. Install the reservoir to the master cylinder.
    2. NOTE: On models that utilize a pin to retain the reservoir, insert the reservoir pin until both of its ends at the right and the left of the reservoir become the same length.
  2. Install the reservoir pin or the screw, as applicable. Install the reservoir diaphragm.
  3. Fill the reservoir. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING BRAKE SYSTEM.
  4. Install the reservoir cap. Inspect for fluid leakage.
  5. Connect the reservoir fluid level connector. See Figure .
scientia non olet · About LEMON Manuals