LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Drum Brake Backing Plate >> Installation

Drum Brake Backing Plate: Installation

  1. Apply General Motors(R) Sealer, (1052366 US; 88900041 Canada), or equivalent, to the mating surface of the rear axle housing.
  2. Install the backing plate to the rear axle housing. Align the holes for the rear axle shaft retainer studs.
  3. Install the park brake cable to the backing plate.
  4. Install the wheel cylinders. See WHEEL CYLINDERS  .
  5. Install the brake shoes. See REAR BRAKE SHOES  .
  6. Apply General Motors(R) Sealer, (1052366 US; 88900041 Canada), or equivalent, to the rear axle shaft bearing retainer mating surface on the backing plate.
  7. Install the following components to the rear axle housing. See appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
    • The rear axle shaft.
    • The rear axle shaft bearing.
    • The ABS reluctor wheel, if equipped.
    • The bearing retainer.
scientia non olet · About LEMON Manuals