LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Overhaul >> Master Cylinder >> Reassembly (ABS)

Reassembly (ABS)

  1. Install the O-ring to the master cylinder. See Fig 1 . Install the following to the master cylinder:
    • The new piston cup.
    • The secondary piston assembly.
    • The new secondary piston pressure cup.
  2. Install the primary piston assembly to the master cylinder. Install the plate. Install the cylinder cup. Install the piston stopper.
  3. Depress and install the piston stopper snap ring into the master cylinder. See Figure . Install the master cylinder to the brake booster. See MASTER CYLINDER  under REMOVAL & INSTALLATION.
  4. Apply a thin coat of brake fluid around the new grommets, and install the grommets to the master cylinder. See Figure . Install the reservoir.
Fig 1: Installing O-Ring To Master Cylinder
G00284635Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals