Park Brake Pedal Assembly: Removal
- Remove the left closeout/insulator panel.
- Remove the push pins from the left half of the sound insulator on the drivers side and remove from the instrument panel (I/P) carrier. See Figure.
- Remove the bolts from the right half of the sound insulator on the drivers side and remove from the I/P carrier.
- Starting at the rear edge, pull the floor carpet retainer upward in order to disengage the retaining clips. Remove the left carpet retainer. Position the carpet aside.
- Remove the PCM and bracket. See POWERTRAIN CONTROL MODULE
under COMPUTERIZED ENGINE CONTROLS in REMOVAL, OVERHAUL & INSTALLATION - MALIBU article in ENGINE PERFORMANCE.
- Remove the park brake pedal assembly nuts. See Fig 1. Remove the park brake pedal assembly.
- Disconnect the electrical connection from the pedal assembly. Remove the park brake cable from the pedal attachment point.
- Using the Parking Brake Cable Release Tool (J-37043), remove the cable from the park brake pedal at attachment point.
Courtesy of GENERAL MOTORS CORP.