LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Malibu Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect the electrical connector from the brake fluid level sensor. See Fig 1.
  2. Remove the brake pipes from the master cylinder.
    NOTE: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Plug the open brake pipe ends.
  4. Remove the master cylinder mounting nuts. See Fig 2. Remove the master cylinder from the vehicle.
Fig 1: Disconnecting Brake Fluid Level Sensor & Brake Pipes From Master Cylinder
G00311311Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Master Cylinder From Vacuum Booster
G00284654Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals