Removal Procedure

Fig 1: Ignition Switch Cylinder Bezel

Courtesy of GENERAL MOTORS CORP.

Using a small flat-bladed tool, remove the bezel from the ignition switch cylinder.

Fig 2: Positioning Transaxle Shift (Impala)

Courtesy of GENERAL MOTORS CORP.

If the vehicle is equipped with a column shift, position the transaxle shift control indicator to 1. Keep the key in the ignition switch cylinder.
Adjust the steering wheel for access.
Remove the steering column filler panel. Refer to Steering Column Filler Replacement .

Fig 3: I/P Fuse Block Access Hole Covers (Impala)

Courtesy of GENERAL MOTORS CORP.

Fig 4: I/P Cluster Trim Plate (Impala)

Courtesy of GENERAL MOTORS CORP.

Remove the screws from the I/P cluster trim plate.
Starting at the right end of the I/P cluster, grasp the trim plate and pull rearward.
Continue working around the I/P cluster trim plate until all of the retainers are released from the I/P trim pad.
Disconnect the electrical connectors from the hazard switch and from the traction control switch, if equipped.
Remove the I/P cluster trim plate.