Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Position the defroster grille to the upper IP. Connect the DRL sensor to the defroster grille. Verify that the DRL sensor wiring harness will not be pinched when the defroster grille is installed.
Courtesy of GENERAL MOTORS CORP.
- Starting at the left side, install the defroster grille retainers into the upper IP. Continue working to the right until all of the retainers are installed.
- Install the garnish moldings to the right and the left windshield pillar. Refer to Garnish Molding Replacement - Windshield Pillar (Impala)
or Garnish Molding Replacement - Windshield Pillar (Monte Carlo)
in Interior Trim.