LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Trim Pad Replacement - Instrument Panel (I/P) Upper (Impala) >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Remove the instrument panel (I/P) cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Monte Carlo) .
  2. Remove the garnish moldings from the left and the right windshield pillar. Refer to Garnish Molding Replacement - Windshield Pillar (Impala) or Garnish Molding Replacement - Windshield Pillar (Monte Carlo) in Interior Trim.
    3. Fig 1: Daytime Running Lamps Sensor
    GM519305Courtesy of GENERAL MOTORS CORP.
  3. Starting at the right side, carefully lift upwards on the defroster grille in order to release the retainers. Continue working to the left side until all of the retainers are released.
  4. Disconnect the daytime running lamps (DRL) sensor from the defroster grille.
  5. Remove the defroster grille.
    6. Fig 2: I/P Upper Trim Pad (Impala)
    GM454282Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws from the I/P upper trim pad.
  7. Remove the remote keyless entry module. Refer to Remote Control Door Lock Receiver Replacement in Keyless Entry.
  8. Disengage the I/P insulator retainers near the glass from the upper trim pad.
  9. Remove the upper trim pad from the I/P.
scientia non olet · About LEMON Manuals