LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Trim Pad Replacement - Instrument Panel (I/P) Upper (Impala) >> Installation Procedure

Installation Procedure

    Fig 1: I/P Upper Trim Pad (Impala)
    GM454282Courtesy of GENERAL MOTORS CORP.
  1. Position the upper trim pad to the I/P.

    Install the remote keyless entry module. Refer to Remote Control Door Lock Receiver Replacement in Keyless Entry.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the I/P upper trim pad screws.

    Tighten: 

    • Tighten the horizontal screws to 2 N.m (18 lb in).
    • Tighten the vertical screws to 10 N.m (89 lb in).

    3. Fig 2: Daytime Running Lamps Sensor
    GM519305Courtesy of GENERAL MOTORS CORP.
  3. Position the defroster grille to the upper I/P. Connect the DRL sensor to the defroster grille. Ensure that the DRL sensor wiring harness will not be pinched when the defroster grille is installed.
  4. Starting at the left side, install the defroster grille retainers into the upper I/P. Continue working to the right side until you have installed all of the retainers.
  5. Install the garnish moldings to the right and the left windshield pillar. Refer to Garnish Molding Replacement - Windshield Pillar (Impala) or Garnish Molding Replacement - Windshield Pillar (Monte Carlo) in Interior Trim.
  6. Install the I/P cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Monte Carlo) .
scientia non olet · About LEMON Manuals