LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: I/P Cluster
    GM519478Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the instrument cluster.
  2. Install the instrument cluster to the I/P.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the instrument cluster screws.

    Tighten:  Tighten the instrument cluster screws to 2 N.m (18 lb in).

  4. Install the I/P cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Monte Carlo) .
  5. If a new instrument cluster was installed, program the cluster. Refer to Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) or Service Programming System (SPS) (Off Board Remote Procedure) or Service Programming System (SPS) (Off Board Pass-Thru Procedure) in Vehicle Control Systems.
scientia non olet · About LEMON Manuals