LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Driver Information Center Replacement (UG1, EXC CF5) >> Installation Procedure

Installation Procedure

    Fig 1: Roof Console Electrical Connectors
    GM546559Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the roof console, apply foam tape to the wiring harness. Secure the wiring harness in the proper position to the headliner.
  1. Apply foam tape to the wiring harness at the headliner.
  2. Install the roof console backing plate.
  3. Connect the electrical connectors to the roof console.
    4. Fig 2: Roof Console Screw
    GM546525Courtesy of GENERAL MOTORS CORP.
  4. Position the roof console to the roof console backing plate in the headliner.
  5. Install the roof console by pressing the console into place until the retainers are completely engaged.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the roof console screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals