Installation Procedure
- Position the roof console backing plate (2) to the headliner opening.
- Secure the wiring harness in the original position to the roof console backing plate.
- Connect the electrical connectors to the roof console.
- Install the headliner. Refer to Headliner Replacement (Impala) or Headliner Replacement (Monte Carlo) in Interior Trim.
- Install the sunshade anchors. Refer to Sunshade Anchor Replacement in Interior Trim.
- Position the roof console to the roof console backing plate in the headliner.
- Install the roof console by pressing the console into place until the retainers are completely engaged.
- Install the to the roof console screw.
Tighten: Tighten the screw to 2 N.m (18 lb in).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.