LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Console Replacement - Front Floor (Impala) >> Installation Procedure

Installation Procedure

    Fig 1: Front Floor Console (Impala)
    GM615736Courtesy of GENERAL MOTORS CORP.
  1. Position the front floor console to the vehicle.
  2. Connect the electrical connectors.
    3. Fig 2: Front Floor Console Clips (Impala)
    GM615823Courtesy of GENERAL MOTORS CORP.
  3. Install the front floor console. Engage the clips at the IP.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the following front floor console bolts:
    • Near the instrument panel (IP)
    • At the transaxle shift control lever
    • Under the mat in the rear bin

      Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  5. Install the trim plate to the front floor console. Refer to Trim Plate Replacement - Front Floor Console (Impala)  or Trim Plate Replacement - Front Floor Console (Monte Carlo) .
scientia non olet · About LEMON Manuals