LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Accessory Power Receptacle Replacement - Floor Console >> Removal Procedure

Removal Procedure

  1. Remove the power accessory port fuse.
    2. Fig 1: Removing Power Accessory Receptacle Using J 42059
    GM658387Courtesy of GENERAL MOTORS CORP.
  2. Remove the power accessory port socket by placing one side of the "T" portion of J 42059  into the tab window. See Special Tools . Angle the other side into the opposite tab window. Pull the power accessory port socket straight out.
    3. Fig 2: Removing Power Accessory Receptacle Using Grinding Tool
    GM906507Courtesy of GENERAL MOTORS CORP.
  3. If the standard method fails to remove the socket, use the following alternate method:
    1. Insert a small grinding tool with a cutoff wheel into the socket.
    2. Remove the plastic latches in the 3-mm (0.11-in) square windows.
    3. Use J 42059  as directed above to remove the socket. See Special Tools .
  4. Remove J 42059  from the power accessory port socket. See Special Tools .
    5. Fig 3: Power Accessory Receptacle Electrical Connector
    GM658570Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the power accessory port.
    6. Fig 4: Removing Receptacle Retainer
    GM658571Courtesy of GENERAL MOTORS CORP.
  6. Using your index finger, pull out the power accessory port retainer.
scientia non olet · About LEMON Manuals