Driver Information Center (DIC) Compass Inaccurate or CAL Displayed
Driver Information Center (DIC) Compass Inaccurate Or CAL Displayed
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Information System Schematics | |||
| 1 | Did you perform the Driver Information Center (DIC) Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Driver Information Systems |
| 2 | Verify that the compass is inaccurate or CAL or C is displayed. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Turn ON the ignition, with the engine OFF. Is the compass display blank? |
Go to Step 7 | Go to Step 4 |
| 4 | Is CAL displayed? | Go to Step 5 | Go to Step 6 |
| 5 | Perform the compass calibration procedure. Refer to Electronic Compass Calibration . Does the compass operate properly? |
Go to Step 8 | Go to Step 6 |
| 6 | Perform the compass variance procedure. Refer to Electronic Compass Calibration . Does the compass operate properly? |
Go to Step 8 | Go to Step 7 |
| 7 |
IMPORTANT:
Perform the compass calibration and variance procedure on the replacement DIC. Replace the DIC. Refer to Driver Information Center Replacement (UG1, EXC CF5) or Driver Information Center Replacement (CF5) .Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |