Conditions for Clearing the DTC
- The DTC becomes history when the DIC no longer detects a failure.
- The history DTC clears after 100 fault free ignition cycles.
- The DIC receives the clear code command from the scan tool.
DTC B0931
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Information System Schematics | |||
| 1 | Did you perform the Driver Information Center Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Driver Information Systems |
| 2 | Is the vehicle equipped with a sunroof? | Go to Step 3 | Go to Step 4 |
| 3 | Inspect for poor connections at the harness connector of the compass. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 5 | Go to Step 4 |
| 4 | Replace the DIC. Refer to Driver Information Center Replacement (UG1, EXC CF5) or Driver Information Center Replacement (CF5) . Did you complete the replacement? |
Go to Step 5 | - |
| 5 |
|
Go to Step 2 | System OK |