LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Avalanche 2500, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

  1. Snap the top of the knee bolster into the I/P assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the knee bolster screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  3. Install the I/P cluster trim plate bezel. Refer to BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER  .
    Fig 1: Installing Top Knee Bolster From Instrument Panel Assembly
    G01458107Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals