LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Avalanche 2500, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Bracket Replacement - Console Floor >> Removal Procedure

Removal Procedure

  1. Remove both front seats. Refer to SEAT REPLACEMENT - FRONT BUCKET in Seats.
  2. Remove the upper console bezel. Refer to BEZEL REPLACEMENT - FLOOR CONSOLE (NON-LUXURY UPPER)  or BEZEL REPLACEMENT - FLOOR CONSOLE (LUXURY UPPER)  or BEZEL REPLACEMENT - FLOOR CONSOLE (NON-LUX LOWER)  .
  3. Remove the cupholder. Refer to CUPHOLDER REPLACEMENT (NON-LUXURY)  or CUPHOLDER REPLACEMENT (LUXURY)  or CUPHOLDER REPLACEMENT (REAR)  .
  4. Remove the screws (1) retaining the console to the I/P.
  5. Move the console assembly rearwards in order to disconnect the wire connectors.
  6. Remove the console assembly from the vehicle.
  7. Remove the console bin. Refer to CONSOLE STORAGE BIN REPLACEMENT (EXPECT PRO)  .
  8. Remove the amplifier and bracket from the console bracket.
  9. Remove the vehicle sensor from the bracket. Refer to YAW RATE SENSOR/LATERAL ACCELEROMETER REPLACEMENT in ANTILOCK BRAKE SYSTEM WITH TCVS & VSES
  10. Remove the fasteners retaining the console to the bracket.
    Fig 1: Removing Console Floor Bracket
    G01458195Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals