Ride Diagnosis - Too Soft

Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, see SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
Verify that the ride is too soft. Does the vehicle ride normally? If so, system is OK. If not, go to next step.
Inspect the tires for the proper inflation pressure. Refer to TIRE INFLATION PRESSURE SPECIFICATIONS . Is the tire inflation pressure correct? If so, go to step 5 . If not, go to next step.
Inflate the tires to the correct pressure. After repairs are complete, go to next step.
Inspect the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE . Repair as necessary. Did you complete the inspection/repair? If so, go to next step.
Inspect the following suspension components for wear or damage:
- Springs
- Struts
- Shock Absorbers
Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING . Are any of the components worn or damaged? If so, go to next step. If not, go to step 8 .
Replace all of the worn or damaged components.
- For any strut component replacement, refer to STRUT, STRUT COMPONENT AND/OR SPRING REPLACEMENT in FRONT SUSPENSION .
- For shock absorber replacement, refer to SHOCK ABSORBER REPLACEMENT ALL WHEEL DRIVE or SHOCK ABSORBER REPLACEMENT FRONT WHEEL DRIVE .
- For spring replacement, refer to COIL SPRING REPLACEMENT ALL WHEEL DRIVE , COIL SPRING REPLACEMENT FRONT WHEEL DRIVE WITH AXLE or COIL SPRING REPLACEMENT FRONT WHEEL DRIVE WITHOUT AXLE in Rear Suspension.
After repairs are complete, go to next step.
Inspect the automatic level control system. Refer to DIAGNOSTIC STARTING POINT - AUTOMATIC LEVEL CONTROL in AUTOMATIC LEVEL CONTROL . Repair as necessary. Did you complete the inspection/repair? If so, go to next step.
Drive the vehicle in order to verify the repair. Did you correct the condition? If so, system is OK. If not, go back to step 3 .