LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Trim Plate Replacement - IP Accessory >> Removal Procedure

Removal Procedure

  1. Open the ashtray or the cupholder.
  2. Remove the following sets of screws:
    • Two screws from the front of the trim panel. For access to the front screws, remove the ashtray or the cupholder.
    • Two screws from the bottom of the trim panel. For access to the bottom screws, remove the console storage box.
  3. Use a small, flat-bladed tool in order to remove the upper tabs on the IP accessory trim plate from the instrument panel.
  4. Disconnect the electrical connectors, if equipped.
  5. Remove the IP accessory trim plate from the instrument panel.
    Fig 1: Removing IP Accessory Trim Plate & Screws
    G01813393Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals