LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Lock Cylinder Replacement - IP Compartment >> Installation Procedure

Installation Procedure

  1. Set the IP compartment latch fork bolt in the up position.
  2. Grasp the IP compartment lock cylinder. Depress the rear-most, light-colored tumbler that is flush with the IP compartment lock cylinder surface.
  3. Insert the key.

    All tumblers will now stay depressed.

  4. Insert the IP compartment lock cylinder, with the key inserted, into the IP compartment latch housing. Ensure that the front projection pin is at the appropriate 8 o'clock position.

    The IP compartment lock cylinder will drop into place.

  5. Rotate the key counterclockwise until the key stops.
  6. Remove the key.

    The IP compartment lock cylinder is now locked into the IP compartment latch housing.

  7. Install the IP compartment latch. Refer to Latch Replacement - IP Compartment .
    Fig 1: Installing IP Compartment Lock Cylinder & Key From IP Compartment Latch
    G01813404Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals