LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Knee Bolster Replacement >> Removal Procedure

Removal Procedure

  1. Remove the IP insulator. Refer to one of the following procedures:
  2. Remove the bolts/screws from the bottom of the knee bolster.
  3. Pull on the knee bolster in order to release the upper clips.
    Fig 1: Removing Bolts/Screws From Bottom Of Knee Bolster
    G01813391Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals