LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

  1. Connect the electrical connectors.
    Fig 1: Installing IP Cluster To Instrument Panel
    G01813415Courtesy of GENERAL MOTORS CORP.
  2. Position the IP cluster to the instrument panel.
    Fig 2: Installing Screws From IP Cluster To Instrument Panel
    G01813416Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the screws to instrument panel cluster.

    Tighten 

    Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the instrument cluster trim plate. Refer to Trim Panel Replacement - IP Cluster .

    When installing a new IP cluster it must be synchronized to the supplemental inflatable restraint (SIR) module in order to synchronize the new cluster. Refer to Instrument Panel Cluster (IPC) Programming/Synchronization  and to Electronic Compass Calibration .

    Fig 3: Installing Instrument Cluster Trim Plate
    G01813417Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals