LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Base, Van Passenger Extended >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> IP Carrier Replacement >> Installation Procedure

Installation Procedure

  1. Position the IP carrier to the body.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts/screws which secure the IP carrier to the body.

    Tighten 

    Tighten the bolts/screws to 25 N.m (18 lb ft).

  3. Install the defroster duct. Refer to AIR OUTLET DUCT REPLACEMENT -- DEFROSTER .
  4. Install the center air outlet. Refer to AIR OUTLET REPLACEMENT -- CENTER .
  5. Install the IP air outlet ducts. Refer to IP AIR OUTLET DUCTS REPLACEMENT .
  6. Install the A/C control module. Refer to HVAC CONTROL MODULE REPLACEMENT .
  7. Install the steering column. Refer to STEERING COLUMN REPLACEMENT .
  8. Install the EBTCM module. Refer to ELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENT .
  9. Install the DRL module. Refer to DAYTIME RUNNING LIGHTS (DRL) CONTROL MODULE R .
  10. Install the body control module. Refer to BODY CONTROL MODULE REPLACEMENT .
  11. Install the wiring harness. Refer to IP Harness Replacement .
  12. Install the instrument panel. Refer to IP Assembly Replacement .
  13. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PRO .
    Fig 1: Installing IP Carrier From Body
    G01813425Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals